Biodiesel SVO Specification 5/16 Super Fuel Hose 8 FEET - NEW Arrival

This is the super fuel hose we have been waiting for! Finally a hose that meats all the needs for running, gasoline, ethonol, diesel, biodiesel, and heated SVO in less than ideal environments. There is nothing else like it on the market today.

• Meets ASTM D 6751 biodiesel requirements up to B100
• Reinforced and braided for super tear resistance
• Abrasion and weather resistant Hypalon cover to protect from external abuse
• Thermoplastic barrier to prevent hydrocarbons from escaping through hose
• Super flexible to prevent kinks in tight bends
• High temp rating to 257 degrees F.

You show me a hose that can out perform this Super-Flex FL hose in all these categories and I will eat it!

This 5/16 ID fuel hose (very close to 8 mm) can be used for a number of different bio-mass fuel applications in 110, 115, 116, 123, 126, 210 and 124 chassis diesels. If you want to replace all your factory hoses to 8 feet is usually more than enough to accomplish this task.

Some think or may have heard that Viton is the only game in town. I believe Super Flex FL is a better all around hose. I prefer to use tough internally braided hoses over Viton because they can take more abuse under the car and in the engine compartment. This special hose made by Parker has a thin internal sheath that prevents any permeation of fuel or fuel vapor into the rubber part of the hose . This hose is IT! We also sell it by the FOOT. Click Here.

Check out our VITON special injector return hose if you are running biodiesel.

WARNING: If you are using this hose to build your own alternative fuel system do not use barbed fittings. CLICK HERE to order the proper non-barbed fittings for this hose. Order the proper fittings to go with this fuel hose

You will also want to make sure to use the problem hose clamps with this hose to get the proper air tight seal to prevent long term damage. DO NOT USE CHEAP HOSE CLAMPS that you get at most hardware and auto parts stores!. Our hose clamps are made in Germany. They are high torque without distortion, they are smooth on the inside so they don't cut into the hose sheath, they don't rust, and they distribute the pressure more evenly so you can get the hose off the non barbed fitting with less effort. These really are Super Hose Clamps. CLICK HERE to order.

Use the proper hose clamps for this hose!