123 Chassis All Models Front Turn Signal Lens Replacement Set

When I first saw these from our supplier I thought I would not sell them as they did not match up to the original Bosch O.E. quality. Then I had to hit myself on the side of the head to realize this - for the price you can not expect them to be like Bosch!!! The originals are hard to get and they list for $174.00 FOR EACH SIDE!

So please keep that in mind if you decide to order. If you are a perfectionist then do NOT order. If you have a low tolerance from less than factory fit then do NOT order. If you need lens replacements and want to save a ton of money and don't mind a little hassle then by all means order. The lens itself is very nice and they look good on the car. But they are a darker orange color than most of the originals and for that reason we will only sell them as a pair. As you can see from the backside NO bulbs or bulb holders are included. You will have to use those from your existing lights.

They also do not come with the plastic thumb nuts that hold the lens to the fender. You will have to use your existing or contact us to add some used ones if you don't have any.

The most difficult part of installing these lenses on the car is getting the rubber seal in place and holding it there while you tighten them down. You may want to use some rubber trim cement or E-6000 to hold the seals in place permanently. There will be some fusing with the seals and once again they will not be as perfect as the original.

NOTE: These take the round three prong bulb sockets. We are not longer able to get these sockets new. If you have the two prong they will fit in the hole, but you will either have to cut / file new notches, or cut off the taps and use a small amount of silicone glue to hold bulb holder in place.