126, Interior

These are the zip ties we have all been looking for. They have a super sticky tape of the foot of the tie so you can stick them anywhere in your engine compartment without having to drill a hole in the inner fender panel. (NOTE: Be sure to thoroughly clean the surface BEFORE installing). The other neat thing is that these zip ties can be loosened back up (just like the factory type) to remove the wire bundle or anything else you need to secure. Sold in packs of 6. You will love these!

This bulb is a single element bulb that is used in the brake light, rear turn signal and your rear back up lens. It's a very universal bulb. Fits mid 60s to 90s Mercedes.

These dash light bulbs are small in size and fit a number of dash light applications behind your instrument cluster and in your center dash console.

These small frosted light bulbs are 1.2 watts and fit applications where you want a dimmer light ie, heater control knob 240D and some other center dash lights.

These bulbs are 5 watts and they fit a number of applications for instance in your instrument cluster. Check to see how many you need.

These bulbs dont neccessary fit all models. This bulb is 1 5/8 inch long. Some applications require smaller bulbs, please measure your bulb before ordering this 6 pak.

These are correct Osram small diameter bulbs for your rear tail light. Use this bulb to prevent over heating of the lens. Comes in a 6 bulbs set.

This is a set of 6 front turn signal light bulbs. Fits early 70s to mid 90s Mercedes.

When changing a front door seal on one of the above chassis you most likely will ending up need new attachments clips (along front edge of door). The majority of the old clips will break when you try to remove them. This set of 6 clips from Mercedes Benz are enough to do one front door.  NOTE: Back door clips on all chassis except the 126 have different clips. These are sure to make installation go more smoothly. 

If you need door seals call or email us. There are vin splits on some models that make it hard to list all. We have great prices on these new seals.

We also have full door seal replacement instructions with special tools. CLICK HERE to order.  

IMPORTANT NOTE: We do not sell replacement antenna masts by year and model. We have run across too many problems with confusion, interchangeability, and previously swapped antennas. We sell a SMOOTH TAIL mast and a TOOTH TAIL mast. Smooth tails were used on most of the power Hirschmann antennas up to the early 80's and tooth tails were used on the later masts. For you to order the proper one you must partially remove your current mast and inspect. Is the white plastic tail more or less smooth or does it have teeth in it? The one describe here is the SMOOTH style. CLICK HERE to view the toothed style.

This relay provides the delay function on your wiper motor. If your wipers are not working in the first postition on you switch it may mean this relay is bad. It is located behind your instrument cluster up close to the firewall on all 123 chassis. On 126 300SD and 380SE it is located inside the fuse box. BRAND NEW KAE relay. Also fits late 107 380SL and 560SL.

If you are looking for an inexpensive way to test the electrical circuits on your Mercedes here is a good option. This tester reads both AC and DC voltage, DC current, resistance, and transistor, diode and battery test. Features automatic zero adjust, overange indication, and low battery indicator. Easy to read LCD readout and comes with 32 inch long test leads. Great for testing battery drains and glow plugs.

If you plan to do much work on your Mercedes these metric wrenches and sockets are very desireable - if not a necessity. If you have wanted to add to your tool box but not spend a lot of money here is your chance. These are not Snap On quality wrenches but if you only work on cars ocassionally these are more than adequate to get the job done. Set includes metric crows feet, metric 3/8 inch drive hex (Allen) sockets, and metric 1/4 inch drive socket set 5 to 14 mm. These items are also available separately. To see a list of all our tools CLICK HERE.

Long drive pin punches are very handy when working on your Benz. The smaller size in this set is particularly helpful when removing and replacing twin pin style brake pads. All steel. Made in India.

Not only does this set include almost 100 pieces but it includes metric sized allen (hex) bits and even an attachment to remove a wing nut! How cool is that? Most kits don't contain metric sizes. There are probably enough screwdriver bits in this kit to last you for a very long. Comes in nice molded red case.

This switch replacement kit will work on all 380SL and 560SL, all 126 chassis sedans and coupes 1981 to 1991 , all 123 chassis from 1982 to 1985, all 201 chassis 190E and 190D and all 124 chassis from 1986 to 1993.

Near perfect door panel from passenger front. Fits 1981 to 1985. No cracks, mint wood, and all plastic tabs intact on back side. How is that for a rare find!

 

I have looked high and low for a good set of METRIC nut driver bits that I can use in an electric drill or magnetic screw driver - and have finally found them! Yea - what a great tool for working around Mercedes - especially if you have one of the new compact and light weight Lithium-Ion Rechargeable drills. Until recently I have not used rechargeable drills much when working on cars because the ones that had enough torque were always too heavy and bulky. Now we have the high torque and light weight of these new technology drills and I am now a convert. I use these bits in my new compact drill almost every day working on all kinds of Mercedes Benz. What a great combination and I highly recommend it to anyone who works on their own cars.

Extra long metric allen sockets with ball ends for hard to reach work areas in and around in engine and body on your Mercedes. Heavy duty black oxide coated chrome vanadium steel. Made in Taiwan. Comes with steel storage clip as shown. Includes sizes 3mm, 4mm, 5mm, 6mm, 7mm, 8mm and 10mm. These measure 6 inches in length and are super handy when working around Mercedes engines (which you a lot of hex head allen bolts). I consider them a must have if you are planning on any major engine work or R and R.

Excellent used horn pad with good rubber and emblem. Fits 123 and 126
chassis from 1981 to 1985.
SKU: INP-COMCHPA

Here is a brand new VDO brand OEM dash light dimmer that fits all 126 chassis, both gas and diesel, from 1981-1991. A bad dimmer is the biggest reason for dash lights not working. We also carry the factory instrument cluster removal tools. The two pull tools allow you to easily remove the cluster without removing the panels under the dash. If you do not have these tools already I highly recommend them to help you install this dash light dimmer. You can view these pulling hooks under our tools section.

SKU: ELT-126DLDS

Fits all 116, 123, and 126 chassis from 1973 to 1991 with automatic transmission. Replace that worn and slippery rubber brake pedal pad now! SKU: BRK-COMRBPP

New inside passenger compartment hood release handle and mounting plate. This fits all 116 chassis sedans from 1973 to 1980 and all 126 sedans and coupes (SEC) from 1981 to 1991. Check yours for cracks now before it completely breaks off! SKU: BDP-COMIHRH

Good used door light switch. Fits almost all 123, 126 chassis. Please look closely at the picture to confirm application.
SKU: ELT-COMDSPS

For all 108, 109, 114, 115, 107, 116, 123, 126, 201, and 124 chassis from 1965 to 1995. I wrote this repair guide to show you how to properly remove your instrument cluster and replace worn or failing components.

This is one great product I recently discovered. It is manufactured for the fluid spill industry and is made from a super tough and highly absorbent material. It is almost an exact match for the factory grey colored Mercedes trunk lining material. It has a dark grey carpet like front and a black rubberized backing so any spills can not go through it. It is perfect for extra protection for your factory carpet or a replacement if yours is missing or badly soiled. It is ideal if you carry containers of any type of fuel in your trunk. This is the perfect material to absorb vegetable oil or diesel fuel spills. It also has great insulation properties. If you are running SVO you can put it around your aux fuel tank in the trunk to both insulate and improve appearance.

This fits 126 sedans 300SD 380SE 1981-1985. This small plastic bracket is often times broken on cars and only available from Mercedes Benz at a outrageous price new. This bolts the center of the arm rest securely to the door panel.

Fits 126 chassis 300SD and 380SE from 1981 to 1985. Good used set of front and rear original black carpets. No tears, no bad stains, and no heavy wear spots. SKU: INP-126BCS

Fits all 126 chassis sedans 1981 to 1991, except for SEL models. Replacing the plastic slide on a broken window regulator with this improved part is a great way to save money and prevent future reoccurrence of this common problem. The original factory part is a two part hollow piece and very prone to breaking apart. The replacement part we offer is a solid piece of plastic and from my experience just does not fail.

This is an nice trunk lip trim piece for a 126 300SD. It has a few small scratches but no cracks and the clips are good. Fits all other 126 sedans from 1981 to 1991. This one is not all beat up like most and decal is still clean and intact. SKU: BDP-126TTP