116, Accessories

Application: Fits all 5 cylinder diesel engines 300SD from 1978 to 1985 and all 300D, 300CD and 300TD from 1980 to 1985 with pencil glow plugs. We have been so impressed with Monark Products that we have recently begun using their glow plugs. They are actually one of the last quality glow plugs still made in Germany. Even Bosch now makes their glow plugs in France, Turkey and other locations in Europe. Now don't get me wrong - Bosch is still a good product. But these Monark glow plugs are superb. They are built with the same materials and have the same specifications as the Duraterm pencil plugs. Even comes with 5 high quality locking nuts for the wires.

PLEASE NOTE: This can only be shipped UPS ground. It can not be shipped via postal or to foreign addresses. If you have any Mercedes model with hydraulic self leveling suspension from the early 70's up to the early 1990's this is the correct fluid to use. High quality Meyle or Febi Bilstein product from Germany. Any other type of fluid can damage the seals and score your pump. Believe it or not, I have seen transmission fluid, jack fluid, and even engine oil in these systems. If your fluid is old and dark it is time to flush it out. Order 3 liters if you are going to do a complete fluid change (you will have a little left over). At the same time you should change the filter located in the top of the fluid tank. CLICK HERE to order filter.

Works on most Early 116, 107, 114, 115 and early 123 models up to the end of the 1970's. This is a genuine Bosch replacement for alternators in those cars that use an internal voltage regulator. If you alternator has a rectangular housing on the outside of the regulator then this is the correct part. DO NOT let anyone tell you to replace your alternator until you have inspected and/or replaced this inexpensive regulator. Even if your old alternator is working pull the regulator and inspect the brushes. If they are worn down short just replace it. This is the best RUN INSURANCE you can get!

Are you running Vegetable oil fuel ( SVO WVO )? If so, here is an emblem you can put on your Benz that you will be proud of. High quality and one of the best looking ones I have seen. Comes with a perfect alignment guage that will let you put it right where you want it and in flawless alignment. Strong self stick 3M adhesive already applied to letter.

******************************************************

If you are running Biodiesel here is an emblem you can put on your Benz that you will be proud of. High quality and one of the best looking ones I have seen. Comes with a perfect alignment guage that will let you put it right where you want it and in flawless alignment. Strong self stick adhesive already applied to letter.

Custom made to order. Expect 5 to 7 days before shipped.

******************************************************

New front INNER wheel bearing with race for one side only. Fits right or left side all 116, 123 and 126 chassis. This is a VERY common wear item on almost all 123 chassis I see come into the shop. Replace at 200,000 miles. We also sell the inner individually or check our complete kit if you need everything. Unless you have the proper tools plan to take your hub to a machine shop to have the race pressed in. List price is $34.50

If you plan to do much work on your Mercedes these metric wrenches and sockets are very desireable - if not a necessity. If you have wanted to add to your tool box but not spend a lot of money here is your chance. These are not Snap On quality wrenches but if you only work on cars ocassionally these are more than adequate to get the job done. Set includes metric crows feet, metric 3/8 inch drive hex (Allen) sockets, and metric 1/4 inch drive socket set 5 to 14 mm. These items are also available separately. To see a list of all our tools CLICK HERE.

This hub cap has one dent on its outer edge and some minor curb scraping. You will need to take off its old paint and repaint it. Its really not a bad hub cap at all! Plus, we'll give you 4 clips for it, how's that for a deal? Fits 1968 to 1985 108, 109, 107, 114, 115, 116, and 123 chassis all  models.

Fits 1968 to 1985 108, 109, 107, 114, 115, 116, and 123 chassis all  models. This buddy has minor curb scraping and just two extraordinarily small dents in its outer edge. There is no paint on it, so you can paint it the color of your choice. Comes with 4 clips.

Brand new Genuine OEM hubcap clip for Chassis 108 114 115 116 107 123. Sold individually so if you need more than one just change your quantity in the cart!

This will fit the standard 14 inch round hubcap on all chassis listed above. 

SKU: BDP-COMHCC

ON SPECIAL! Very compact and handy three piece detail brush set. These measure 7 inches long and include one plastic bristle, one brass bristle and one stainless bristle brush. The plastic one is ideal for interior and exterior detailing when you don't want to scratch your paint or trim. The brass brush works great around the engine when you need more bristle strength but still don't want to scratch your steel or aluminum parts ( very good for cleaning diesel fuel injector tips), and the stainless brush is perfect for getting into small places to clean rust and corosion in preparation for Miracle Paint application.

SKU: TUL-COM3PDB

If your pan plug is worn, leaking or rounded off, don't fight it anymore! Buy a new pan plug and copper sealing ring and stop those unsightly oil drips now. This is the small 13 mm head factory pan drain bolt that came on 240D, 300D, 300CD, 300TD and 300SD from 1974 to 1985

 SKU: DSL-COMDOPP

This is a great product and well suited for WVO installations. If you have wanted something stronger than the standard zip tie - here it is. These you cannot break, and they hold up to high heat well! Once you install them you can not get them off without cutting and they will not rust under the car.

Includes the following:

• 10 twelve inch long stainless zip ties

SKU: GOC-HDWSZT

This booklet can apply to any chassis 107, 114, 123, 116 up to 1980 with manual controls on Becker Grand Prix.  This is a very nice set of books including the data tag, the instruction booklet and the wiring diagram. Included is the original red plastic pouch that came with this book set.

Regular price was $29.50

SKU: FMB-COMGPBI

This is a great item to have on hand when you are working on and around your Mercedes. This is a high quality Blue threadlocker compound to keep nuts and bolts tightly fastened. It is temperature and chemical resistant and also waterproof! Holds things in place that can loosen due to vibration, and we all know how much old diesels vibrate! Parts are removeable later on with ordinary tools. Stash in your toolbox today!

SKU: BDP-COMBTC

Fits all 116 Chassis 1973-1980. The best way to restore the original ride and feel of your Mercedes is to replace your shocks with new Bilsteins. There is no other shock that will perform as well. These are OEM COMFORT shocks that give you the smoothest ride. If you car has a lot of body roll or the front end is bouncing more than it use to it is time to replace your shock absorbers.

RED WHITE AND BLUE SPECIAL - ON SALE THRU JULY

FITS All 107, 116 and 123 chassis. Have you been having electrical problems in your older chassis Mercedes? Maybe you have taken the fuse box cover off and wiggled a few fuses and it has solved the problem for a while. You probably noticed corossion on the tips of the old aluminum fuses. Who ever designed these old fuses did not get a good education in dissimilar metal corrosion. You do not put aluminum up next to copper - add in moisture and heat and expect to not have corrosion problems.